Valence and conduction bands

Filling of the electronic states in various types of materials at equilibrium. Here, height is energy while width is the density of available states for a certain energy in the material listed. The shade follows the Fermi–Dirac distribution (black = all states filled, white = no state filled). In metals and semimetals the Fermi level E_F lies inside at least one band. In insulators and semiconductors the Fermi level is inside a band gap; however, in semiconductors the bands are near enough to the Fermi level to be thermally populated with electrons or holes.

In solid-state physics, the valence band and conduction band are the bands closest to the Fermi level and thus determine the electrical conductivity of the solid. The valence band is the highest range of electron energies in which electrons are normally present at absolute zero temperature, while the conduction band is the lowest range of vacant electronic states. On a graph of the electronic band structure of a material, the valence band is located below the Fermi level, while the conduction band is located above it. This distinction is meaningless in metals as the highest band is partially filled, taking on the properties of both the valence and conduction bands.

Band gap

In semiconductors and insulators the two bands are separated by a band gap, while in semimetals the bands overlap. A band gap is an energy range in a solid where no electron states can exist due to the quantization of energy. Electrical conductivity of non-metals is determined by the susceptibility of electrons to excitation from the valence band to the conduction band.

Electrical conductivity

Semiconductor band structure
See electrical conduction and semiconductor for a more detailed description of band structure.

In solids, the ability of electrons to act as charge carriers depends on the availability of vacant electronic states. This allows the electrons to increase their energy (i.e., accelerate) when an electric field is applied. This condition is only satisfied in the conduction band, since the valence band is full in non-metals.

As such, the electrical conductivity of a solid depends on its capability to flow electrons from the valence to the conduction band. Hence, in the case of a semimetal with an overlap region, the electrical conductivity is high. If there is a small band gap (E_g), then the flow of electrons from valence to conduction band is possible only if an external energy (thermal, etc.) is supplied; these groups with small E_g are called semiconductors. If the E_g is sufficiently high, then the flow of electrons from valence to conduction band becomes negligible under normal conditions; these groups are called insulators.

There is some conductivity in semiconductors, however. This is due to thermal excitation—some of the electrons get enough energy to jump the band gap in one go. Once they are in the conduction band, they can conduct electricity, as also can the hole they left behind in the valence band. The hole is an empty state that allows electrons in the valence band some degree of freedom.

See also

• Electrical conduction for more information about conduction in solids, and another description of band structure.
• Electronic band structure
• Fermi sea
• Semiconductor for a full explanation of the band structure of materials.
• HOMO/LUMO
• Valleytronics

References

• "Chembio".
• "Hyperphysics".
• Kittel, Charles (2005). Introduction to Solid State Physics. Wiley. ISBN 0-471-41526-X.

External links

• Direct Band Gap Energy Calculator