Hybrid Wireless Mesh Protocol

Hybrid Wireless Mesh Protocol (HWMP) defined in IEEE 802.11s, is a basic routing protocol for a wireless mesh network. It is based on AODV (RFC 3561) and tree-based routing.[1] It relies on a Peer Link Management protocol by which each Mesh Point discovers and tracks neighboring nodes. If any of these are connected to a wired backhaul, there is no need for HWMP, which selects paths from those assembled by compiling all mesh point peers into one composite map.

HWMP protocol "is hybrid, because it supports two kinds of path selection protocols. Although these protocols are very similar to routing protocols, but bear in mind, that in case of IEEE 802.11s these use MAC addresses for "routing", instead of IP addresses. Therefore, we use the term "path" instead of "route" and thus "path selection" instead of "routing"".

HWMP is intended to displace proprietary protocols used by vendors like Meraki for the same purpose, permitting peer participation by open source router firmware. The open source implementation of 802.11s has been integrated to Linux kernel by Cozybit. Inc. and can be found at [2]

References

  1. ↑ "HWMP Protocol specification". The Working Group for WLAN Standards of the Institute of Electrical and Electronics Engineers. November 2006. Retrieved 2009-05-03.
  2. ↑ https://github.com/cozybit/open80211s


This article is issued from Wikipedia - version of the 11/8/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.