IEC 60228

IEC 60228 is the International Electrotechnical Commission's international standard on conductors of insulated cables. The current version is Third Edition 2004-11 ^[1] Among other things, it defines a set of standard wire cross-sectional areas:

International standard wire sizes (IEC 60228)
0.5 mm^2	0.75 mm^2	1 mm^2	1.5 mm^2	2.5 mm^2	4 mm^2
6 mm^2	10 mm^2	16 mm^2	25 mm^2	35 mm^2	50 mm^2
70 mm^2	95 mm^2	120 mm^2	150 mm^2	185 mm^2	240 mm^2
300 mm^2	400 mm^2	500 mm^2	630 mm^2	800 mm^2	1000 mm^2

In engineering applications, it is often most convenient to describe a wire in terms of its cross-section area, rather than its diameter, because the cross section is directly proportional to its strength and weight, and inversely proportional to its resistance. The cross-sectional area is also related to the maximum current that a wire can carry safely.

This document is one considered Fundamental in that it does not contain reference to any other standard.

Description

The document describes several aspects of the conductors for electrical cables

Class

This refers to the flexibility of a conductor

• Class 1: Solid conductor
• Class 2: Stranded conductor intended for fixed installation
• Class 5: Flexible conductor
• Class 6: Very Flexible conductor

Size

The nominal (see below) cross-sectional area for standard conductors including the following:

• Class 2: Minimum number of strands required to make particular conductor size
• Class 5&6: Maximum diameter of any component strand of the conductor

Resistance

The maximum permissible resistance (in ohms/km)of each conductor size, class and type (both plain copper and metal coated)

Purpose of the document

This document and its precursors were created due to a need for a standard definition of cable conductor size. The main problem being that not all copper has the same resistivity value, so, for example, a 4mm² conductor from two different suppliers may have different resistance values. Instead this document describes conductors by their nominal size, determined by resistance rather than physical dimensions. This is a key distinction as it makes a standardized definition of conductors based solely on their electrical characteristics.

Almost all characteristics of conductors, resistance, current carrying capacity etc. are independent of the physical dimensions of the conductor. However this document allows an easy reference whereby the standard conductor sizes and reference to physical dimensions are maintained but given an exact meaning in terms of the electrical characteristics of a conductor.

See also

• Wire gauge comparison chart
• Circular mil, Electrical industry standard for wires larger than 4/0.
• American Wire Gauge (AWG), used primarily in the US and Canada
• Standard Wire Gauge (SWG), the British imperial standard BS3737, superseded by the metric.
• Stubs Iron Wire Gauge
• Jewelry wire gauge
• Body jewelry sizes
• Electrical wiring
• Number 8 wire, a term used in the New Zealand vernacular

References

1. http://webstore.iec.ch/preview/info_iec60228%7Bed3.0%7Den_d.pdf

External links

• "IEC 60228" at International Electrotechnical Commission