Crop factor

The outer, red box displays what a 24×36 mm sensor would see, the inner, blue box displays what a 15×23 mm sensor would see. (The actual image circle of most lenses designed for 35 mm SLR format would extend further beyond the red box than shown in the above image.)

In digital photography, the crop factor of an image sensor format is related to the ratio of the dimensions of a camera's imaging area compared to a reference format; most often, this term is applied to digital cameras, relative to 35 mm film format as a reference. In the case of digital cameras, the imaging device would be a digital sensor. The most commonly used definition of crop factor is the ratio of a 35 mm frame's diagonal (43.3 mm) to the diagonal of the image sensor in question; that is, CF=diag35mm / diagsensor. Given the same 3:2 aspect ratio as 35mm's 36mm x 24mm area, this is equivalent to the ratio of heights or ratio of widths; the ratio of sensor areas is the square of the crop factor.

The crop factor is used to compare the field of view and image quality of different cameras with the same lens: The crop factor is commonly referred to as the focal length multiplier ("FLM") since multiplying a lens focal length by the crop factor or FLM gives the focal length of a lens that would yield the same field of view if used on the reference format. For example, a lens with a 50 mm focal length on an imaging area with a crop factor of 1.6 with respect to the reference format (usually 35 mm) will yield the same field of view that a lens with an 80 mm focal length will yield on the reference format. If you want to capture an image with the same field of view and image quality but different cameras, the aperture and ISO settings also need to be adjusted with respect to the crop factor.[1] It is important to note that the focal length of the lens does not change by using a smaller imaging area; the field of view is correspondingly smaller because a smaller area of the image circle cast by the lens is used by the smaller imaging area.

The term format factor is sometimes also used, and is a more neutral term that corresponds to the German word for this concept, Formatfaktor.

Introduction

A 50 mm lens on an APS-C format (crop factor 1.6) images a slightly smaller field of view than a 70 mm lens on a 35 mm camera.

The terms crop factor and focal length multiplier were coined in recent years in an attempt to help 35 mm film format SLR photographers understand how their existing ranges of lenses would perform on newly introduced DSLR cameras which had sensors smaller than the 35 mm film format, but often utilized existing 35 mm film format SLR lens mounts. Using an FLM of 1.5, for example, a photographer might say that a 50 mm lens on a DSLR "acts like" its focal length has been multiplied by 1.5, which means that it has the same field of view as a 75 mm lens on the film camera that they are more familiar with. Of course, the actual focal length of a photographic lens is fixed by its optical construction, and does not change with the format of the sensor that is put behind it.

Most DSLRs on the market have nominally APS-C-sized image sensors, smaller than the standard 36 × 24 mm (35 mm) film frame. For example, many Canon DSLRs use an APS-C sensor that measures 22.2 mm × 14.8 mm. The result is that the image sensor captures image data from a smaller area than a 35 mm film SLR camera would, effectively cropping out the corners and sides that would be captured by the 36 mm × 24 mm 'full-size' film frame.

Because of this crop, the effective field of view (FOV) is reduced by a factor proportional to the ratio between the smaller sensor size and the 35 mm film format (reference) size.

For most DSLR cameras, this factor is 1.3–2.0×. For example, a 28 mm lens delivers a moderately wide-angle FOV on a 35 mm format full-frame camera, but on a camera with a 1.6 crop factor, an image made with the same lens will have the same field of view that a full-frame camera would make with a ~45 mm lens (28 × 1.6 = 44.8). This narrowing of the FOV is a disadvantage to photographers when a wide FOV is desired. Ultra-wide lens designs become merely wide; wide-angle lenses become 'normal'. However, the crop factor can be an advantage to photographers when a narrow FOV is desired. It allows photographers with long-focal-length lenses to fill the frame more easily when the subject is far away. A 300 mm lens on a camera with a 1.6 crop factor delivers images with the same FOV that a 35 mm film format camera would require a 480 mm long focus lens to capture.

Estimating sensor performance

For a given exposure, for example for a fixed focal-plane illuminance and exposure time, larger image sensors capture more photons and hence produce images with less image noise and greater dynamic range than smaller sensors. Due to the statistics of photon shot noise, the desirable properties of signal-to-noise ratio (SNR) and sensor unity gain both scale with the square root of pixel area.[2]

Since crop factor is inversely proportional to the square root of sensor area (to within a small aspect ratio-dependent factor), it is useful for estimating image sensor performance. For example, if two different-sized image sensors have the same aspect ratio and a resolution of 10 megapixels, and are made using similar technology, the larger sensor will have better signal-to-noise ratio by a factor equal to the ratio of the two sensors' crop factors. The larger sensor has the smaller crop factor and the higher signal-to-noise ratio.

Digital lenses

An APS-C format SLR (left) and a full-frame DSLR (right) show the difference in the size of the image sensors.

Most SLR camera and lens manufacturers have addressed the concerns of wide-angle lens users by designing lenses with shorter focal lengths, optimized for the DSLR formats. In most cases, these lenses are designed to cast a smaller image circle that would not cover a 24×36 mm frame, but is large enough to cover the smaller 16×24 mm (or smaller) sensor in most DSLRs. Because they cast a smaller image circle, the lenses can be optimized to use less glass and are sometimes physically smaller and lighter than those designed for full-frame cameras.

Lenses designed for the smaller digital formats include Canon EF-S and EF-M lenses, Nikon DX lenses, Olympus Four Thirds System lenses, Sigma DC lenses, Tamron Di-II lenses, Pentax DA lenses, Fujifilm XF and XC lenses,and Sony Alpha (SAL) DT & E lenses. Such lenses usually project a smaller image circle than lenses that were designed for the full-frame 35 mm format. Nevertheless, the crop factor or FLM of a camera has the same effect on the relationship between field of view and focal length with these lenses as with any other lens, even though the projected image is not as severely "cropped". In this sense, the term crop factor sometimes has confusing implications; the alternative term "focal length multiplier" is sometimes used for this reason.

Crop factor of point-and-shoot cameras

Some manufacturers provide both the real focal length and the 35 mm equivalent focal length

Smaller, non-DSLR, consumer cameras, typically referred to as point-and-shoot cameras, can also be characterized as having a crop factor or FLM relative to 35 mm format, even though they do not use interchangeable lenses or lenses designed for a different format. For example, the so-called "1/1.8-inch" format with a 9 mm sensor diagonal has a crop factor of almost 5 relative to the 43.3 mm diagonal of 35 mm film. Therefore, these cameras are equipped with lenses that are about one-fifth of the focal lengths that would be typical on a 35 mm point-and-shoot film camera. In most cases, manufacturers label their cameras and lenses with their actual focal lengths, but in some cases they have chosen to instead multiply by the crop factor (focal length multiplier) and label the 35 mm equivalent focal length. Reviewers also sometimes use the 35 mm-equivalent focal length as a way to characterize the field of view of a range of cameras in common terms.

For example, the Canon Powershot SD600 lens is labeled with its actual focal length range of 5.8–17.4 mm. But it is sometimes described in reviews as a 35–105 mm lens, since it has a crop factor of about 6 ("1/2.5-inch" format).[3]

Magnification factor

The crop factor is sometimes referred to as "magnification factor",[4] "focal length factor" or "focal length multiplier".[5] This usage reflects the observation that lenses of a given focal length seem to produce greater magnification on crop-factor cameras than they do on full-frame cameras. This is an advantage in, for example, bird photography, where photographers often strive to get the maximum "reach". A camera with a smaller sensor can be preferable to using a teleconverter, because the latter affects the f-number of the lens, and can therefore degrade the performance of the autofocus.

A given lens casts the same image no matter what camera it is attached to. The extra "magnification" occurs when the image is enlarged more to produce output (print or screen) that matches a standard output size. That is, the magnification, as usually defined from subject to focal plane, is unchanged, but the system magnification from subject to final output is increased.

Field-of-view crop is cameras of different sensor size but the same lens focal length
Field-of-view crop in cameras of different sensor size but the same lens focal length.

Secondary effects

When a lens designed for 35 mm format is used on a smaller-format DSLR, besides the obvious reduction in field of view, there may be secondary effects on depth of field, perspective, camera-motion blur, and other photographic parameters.

The depth of field may change, depending on what conditions are compared. Shooting from the same position, with the same lens and same f-number as a non-cropped (full-frame) 35 mm camera, but enlarging the image to a given reference size, will yield a reduced depth of field. On the other hand, using a different lens with the same field of view as the non-cropped camera (matching the 35 mm-equivalent focal length), at same f-number, the smaller camera's depth of field is greater.

Perspective is a property that depends only on viewpoint (camera position). But if moving a lens to a smaller-format camera causes a photographer to move further from the subject, then the perspective will be affected.

The extra amount of enlargement required with smaller-format cameras increases the blur due to defocus, and also increases the blur due to camera motion (shake). As a result, the focal length that can be reliably hand-held at a given shutter speed for a sharp image is reduced by the crop factor. The old rule of thumb that shutter speed should be at least equal to focal length for hand-holding will work equivalently if the actual focal length is multiplied by the FLM first before applying the rule.

Many photographic lenses produce a superior image in the center of the frame than around the edges. When using a lens designed to expose a 35mm film frame with a smaller-format sensor, only the central "sweet spot" of the image is used; a lens that is unacceptably soft or dark around the edges can give better results on a smaller sensor.[6] However, since the image projected onto the sensor must be magnified more to make a print using a smaller sensor, lenses used on smaller formats must deliver a higher-resolution image to the sensor for acceptable quality.

Common crop factors

Crop factor figures are useful in calculating 35 mm equivalent focal length and 35 mm equivalent magnification. Some common crop factors are:

Type Height (mm) Crop factor[7]
1/2.5" (many superzoom and point-and-shoot cameras) 4.29 6.0
1/2.3" (compacts and compact superzooms, earlier Pentax Q) 4.55 5.6
1/1.8" (high-end compacts like Canon Powershot G1 - G7/S90) 5.32 4.8
1/1.7" (high-end compacts, later Pentax Q) 5.70 4.5
2/3" (Fujifilm X10, Fujifilm X20, Sony F828, Sony F717) 6.60 3.9
1" (Nikon 1/CX / Sony RX100-series / Sony RX10 / Canon Powershot G7 X) 8.80 2.7
Four Thirds, Micro Four Thirds (used by Olympus and Panasonic for DSLR and MILC respectively) 13 1.84–2[8]
Sigma Foveon X3 (prior to Merrill cameras) 13.80 1.7
Canon APS-C 14.80 1.6
General APS-C (Sigma Foveon X3, Fujifilm X-mount, Nikon DX, Pentax K, Ricoh GXR, & Ricoh GR, Samsung NX, Minolta/Sony α DT & E-Mount (NEX)) 15.60 1.5
APS-H (Canon, Leica M8) 18.60 1.3
35mm full frame (Canon EF, Leica M9, Nikon FX, Sony α, FE-Mount, Sony RX1) 24.00 1.0
Medium format (Hasselblad, Leaf, Phase One, Pentax 645D) 33.00 0.79
Medium format (Hasselblad, Leaf, Phase One) 40.40 0.64

See also

References

  1. Affects of crop factor on focal length, aperture, and ISO.
  2. Clark, R. N. "Digital Camera Sensor Performance Summary". Retrieved 2007-12-06.
  3. Canon SD600 specs.
  4. Dan Heller (2007). Digital Travel Photography: Shooting People and Places Like the Pros. Sterling Publishing Co. ISBN 1-57990-973-6.
  5. Tom Ang (2003). Advanced Digital Photography. Amphoto Books. ISBN 0-8174-3273-6.
  6. Ophrys Photography, Full frame vs crop camera comparisons.
  7. Defined here as the ratio of the vertical height of a full 35 frame to that of the sensor format, that is CF=Height24mm / Height sensor.
  8. Depending on aspect ratio; 2 is most commonly used.

External links

This article is issued from Wikipedia - version of the 10/30/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.