PWS-8
| PWS-8 | |
|---|---|
 | |
| PWS-8 during the Challenge contest | |
| Role | Sports plane |
| Manufacturer | PWS |
| First flight | 1929/1930 |
| Introduction | 1930 |
| Status | prototype |
| Number built | 1 |
|
| |
The PWS-8 was a Polish sports plane of 1930, constructed by the Podlaska Wytwórnia Samolotów (PWS), that remained a prototype.
Design and development
The plane was designed in 1929 by Jarosław Naleszkiewicz in Podlaska Wytwórnia Samolotów, on factory's initiative, to participate in the Challenge 1930 international touring aircraft contest (with PWS-50, PWS-51 and PWS-52). It was a wooden biplane, partly modelled after de Havilland Gipsy Moth.[1] Its unique feature, taken from earlier PWS military aircraft, like PWS-5, were N-shaped struts between lower and upper wing and additional oblique transverse struts, stiffening the design, instead of wire braces (similar bracing to Handley Page Gugnunc[2]).
The plane was first flown in 1929/1930 by F. Rutkowski, with Armstrong Siddeley Genet 80 hp radial engine. In spring of 1930 it was modified, with Walter Vega 85 hp radial engine, also a tailfin shape and some other details were changed. It was however too heavy for engines used (65 kg heavier, than designed).[1]
The plane was a counterpart of PZL.5 for a sportsplane and trainer, but was worse, and as a result, remained a prototype.[1] Its major fault was low speed, especially in a view of competition purpose.
Operational history
The prototype, with markings SP-ADA, took part in the Challenge 1930 international contest in July 1930, flown by Piotr Dudziński. He was disqualified for time infringement during a rally over Europe, but completed the rally off the contest.[3]
Later the plane was used for a short time by an Aviation Club of the PWS factory.[1] Possibly it was broken up by 1931, because there is information about its engine being used in the repaired PWS-51.[1]
Description
The PWS-8 was a wooden construction braced biplane. A fuselage was rectangular in cross-section, with plywood skin, except for an engine section, which was duralumin sheet covered. The wings were rectangular three-section, two-spar, with rounded tips, canvas covered (plywood covered on a leading edge). The ailerons were on a lower wing, which had a smaller span of 9 m. The wings were folding rearwards (width with folded wings was 2.95 m). Crew of two, sitting in tandem in open cockpits with windshields. Cockpits with dual controls (a front cockpit had removable steering stick). The third cab could be set up in a baggage compartment behind.[1]
The plane had 5-cylinder air-cooled radial engine Walter Vega in front, developing 85 hp nominal power and 90 hp take-off power. Two-blade wooden propeller Heine of a fixed pitch. Conventional fixed landing gear, with a rear skid. Fuel tank 125 l in upper central wing section (additional 60 l tank could be mounted in the fuselage front). Fuel consumption - 22 l/hour.
Specifications
Data from Glass, A. (1977)
General characteristics
- Crew: 1, pilot
- Capacity: 1, student or passenger
- Length: 7.5 m ()
- Wingspan: 10 m ()
- Height: 2.95 m ()
- Wing area: 22.1 m² ()
- Empty weight: 455 kg ()
- Useful load: 320 kg ()
- Loaded weight: 775 kg ()
- Powerplant: 1 × Walter Vega 5-cylinder air-cooled radial engine, 85 hp ()
Performance
- Maximum speed: 136 km/h
- Cruise speed: 125 km/h
- Stall speed: 72 km/h ()
- Range: 700 km ()
- Service ceiling: 3,000 m ()
- Rate of climb: 2.4 m/s ()
- Wing loading: 35 kg/m² ()
See also
- Aircraft of comparable role, configuration and era
References
- Andrzej Glass: "Polskie konstrukcje lotnicze 1893-1939" (Polish aviation constructions 1893-1939), WKiŁ, Warsaw 1977 (Polish language, no ISBN)
External links
 |
Wikimedia Commons has media related to PWS-8. |