SM-65C Atlas

Atlas C (SM-65C)

Atlas C awaiting launch (USAF)
Function Prototype ICBM
Manufacturer Convair
Country of origin United States
Launch history
Status Retired
Launch sites LC-12, CCAFS
Total launches 6
Successes 3
Failures 3
First flight 24 December 1958
Last flight 24 August 1959

The SM-65C Atlas, or Atlas C was a prototype of the Atlas missile. First flown on 24 December 1958, the Atlas C was the final development version of the Atlas rocket, prior to the operational Atlas D. It was originally planned to be used as the first stage of the Atlas-Able rocket, but following an explosion during a static test on 24 September 1959, this was abandoned in favor of the Atlas D. Atlas C was similar to Atlas B, but had a larger LOX tank and smaller RP-1 tank due to technical changes to the Rocketdyne engines. Improvements in materials and manufacturing processes also resulted in lighter-weight components than the Atlas A and B. All launches took place from LC-12 at CCAS.

The Alas C test program began with the successful flight of 3C on December 24, 1958. On January 27, Missile 4C's guidance system quit working about a minute into flight, but the flight control system managed to compensate. The missile overshot its intended impact point in the South Atlantic by about 40 miles (64 km). The guidance system failure prevented the separation signal from being sent to the RV, which remained attached to the missile until impact.

Missile 5C (February 20) was a complete failure when the fuel staging disconnect valve did not close properly at booster separation. Fuel tank pressure was lost, leading to reversal of the intermediate bulkhead and missile self-destruction at T+172 seconds.

Missile 7C (March 19) suffered from a series of electrical gremlins when the guidance system failed at T+85 seconds, followed by premature booster cutoff at T+129 seconds. The Atlas's programmer sent a command to jettison the booster section at T+151 seconds, the point where normal BECO was supposed to occur. The sustainer engine thus burned until T+282 seconds, well past its normal cutoff point. Vernier cutoff took place at T+311 seconds. The Atlas traveled along an unstable trajectory for the remainder of powered flight, which made it impossible to determine where impact would occur. As such, the planned recovery of the RVX-2 reentry vehicle, which also failed to separate from the missile, was abandoned.

The final two C-series flights (8C on July 21 and 11C on August 24) were successful. Missile 8C was the third attempt to fly an RVX-2 reentry vehicle (the second attempt on a D-series Atlas had failed three months earlier) and the first successful one. Sixty-three minutes after launch, it was successfully recovered. Missile 11C carried a movie camera in the nose cone which filmed missile separation and a large portion of the Earth's surface on a 250-mile (402 km) lob, taking it to an apogee of 700 miles (1126 km). Recovery of the film capsule was successful.

One of the more significant upgrades to the Atlas C was the addition of motion detectors in the gyroscope package to ensure proper operation. This was implemented after the first B-series Atlas had failed in flight due to launch crews neglecting to power on the gyroscopes and would soon become a standard part of all ballistic missile guidance systems.

Missile 9C was designated for the first Atlas-Able lunar probe launch, which was scheduled to launch on October 2, 1959 from LC-12 at Cape Canaveral. The vehicle was similar to Missiles 10B and 13B in that it had several weight saving modifications as well as modified vernier start tanks.

NASA had wanted to use the operational Atlas D rather than the developmental Atlas C, but there were no available Atlas D missiles for the Able program, so instead they were forced to use an Atlas C.

On September 24, the Atlas was prepared for a planned 12-minute PFRT (Pre-Flight Readiness Test). The satellite was not on the launch vehicle, the third stage was a dummy, and the second stage was unfueled. After 2.5 seconds of engine operation, a fire erupted in the Atlas's thrust section. Fed by leaking liquid oxygen, it proved impossible to put out with pad extinguishers and soon a huge inferno was raging on LC-12. Thirty-seven seconds after the fire began, the Atlas toppled over in a massive fireball, the biggest explosion seen at Cape Canaveral up to that point. The pad was severely damaged, with both umbilical towers totally destroyed, the concrete launch stand caved in, and the service tower knocked over. It would take months of repairs to get it back online. The final explosion was believed to be the result of loss of tank pressure. Engine shutdown caused the propellant valves to snap shut, causing overpressurization of the propellant tanks. Ground operators in the blockhouse flipped manual override switches to lower RP-1 pressure and increase LOX pressure, but the missile did not respond, possibly due to fire-induced damage to the control wiring on the pad. The pneumatic control system automatically threw open the LOX boil-off valve to vent tank pressure, which apparently continued until the tanks lost support pressure to the point where their structural integrity failed. At around 35 seconds, the intermediate bulkhead collapsed, causing the LOX to fall into the RP-1 tank and mix. The propellants turned into a gel that detonated with the force of 20,000 pounds (9070 kg) of TNT and resulted in an extremely powerful explosion that caused extensive pad damage.

Investigators concluded that the disaster was due to the above-mentioned configuration change on the Atlas C, in addition to several weight-saving modifications unique to Missile 9C. When the Atlas was assembled at Convair, workmen attached a helium vent line to a port near the bottom of the RP-1 tank, below the anti-slosh baffles. On the Atlas B missiles, the vernier helium tank was mounted in a higher location resulting in a different fuel tank attachment point above the baffles. Helium pressure gas from the vernier propellant tanks leaked into the sustainer RP-1 turbopump, leading to cavitation which caused propellant unloading, pump overspeed, and rupture of the propellant lines. This then caused the fire that led to vehicle destruction. It was not clear whether the fire had been started by rupture of a LOX duct due to sudden pressure change from the helium venting or rubbing of the turbopump blades against the metal casing due to overspeed caused by the pump running without propellant in it. The accident was ultimately ruled to be the result of poor engineering judgement in attaching the vernier helium vent line to the bottom of the RP-1 tank.

Six flights were made. These were all sub-orbital test flights of the Atlas as an Intercontinental Ballistic Missile, with three tests succeeding, and three failing.

All Atlas C launches were conducted from Cape Canaveral Air Force Station, at Launch Complex 12.

Launch history

Date Time (GMT) Serial Apogee Outcome
1958-12-24 04:45 3C 900 kilometres (560 mi) Success
1959-01-27 23:34 4C 900 kilometres (560 mi) Partial failure. Guidance system failed, however the flight control system managed to keep the missile on a stable path and impact was close to the target point.
1959-02-20 05:38 5C 100 kilometres (62 mi) Failure. Valve malfunction during staging led to loss of tank pressure and reversal of the intermediate bulkhead. The missile destroyed itself at T+174 seconds.
1959-03-19 00:59 7C 200 kilometres (120 mi) Partial failure. Premature booster engine shutdown due to an electrical malfunction at T+131 seconds led to an unstable flight trajectory.
1959-07-21 05:22 8C 900 kilometres (560 mi) Success
1959-08-24 15:53 11C 900 kilometres (560 mi) Success

See also

References

This article is issued from Wikipedia - version of the 11/26/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.