Sebacoyl chloride

Sebacoyl chloride
Names
Preferred IUPAC name
Decanedioyl dichloride
Other names
Sebacoyl dichloride
Identifiers
111-19-3 YesY
3D model (Jmol) Interactive image
ChemSpider 59462 N
ECHA InfoCard 100.003.495
EC Number 203-843-4
MeSH C061659
PubChem 66072
Properties
C10H16Cl2O2
Molar mass 239.14 g/mol
Density 1.12 g cm−3
Melting point −2.5 °C (27.5 °F; 270.6 K)
Boiling point 220 °C (428 °F; 493 K)
Hazards
Safety data sheet External MSDS
NFPA 704
Flammability code 0: Will not burn. E.g., water Health code 3: Short exposure could cause serious temporary or residual injury. E.g., chlorine gas Reactivity code 2: Undergoes violent chemical change at elevated temperatures and pressures, reacts violently with water, or may form explosive mixtures with water. E.g., phosphorus Special hazard W: Reacts with water in an unusual or dangerous manner. E.g., cesium, sodiumNFPA 704 four-colored diamond
0
3
2
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa).
N verify (what is YesYN ?)
Infobox references

Sebacoyl chloride (or sebacoyl dichloride) is a di-acyl chloride, with formula C10H16Cl2O2.

Sebacoyl chloride is a light-yellow liquid with a pungent odor, soluble in hydrocarbons and ethers. Sebacoyl chloride is corrosive; like all acyl chlorides, it hydrolyzes in water, evolving hydrogen chloride. It is less susceptible to hydrolysis though than shorter chain aliphatic acyl chlorides.[1]

Preparation

Sebacoyl chloride can be prepared by reacting sebacic acid with an excess of thionyl chloride. Residual thionyl chloride can be removed by distillation.[2]

Use

Sebacoyl chloride can be polymerized with hexamethylenediamine yielding nylon-6,10.[3]

See also

References

  1. ↑ Morgan, Paul W.; Kwolek, Stephanie L. (April 1959). "The nylon rope trick: Demonstration of condensation polymerization". Journal of Chemical Education. 36 (4): 182. doi:10.1021/ed036p182.
  2. ↑ Erdmann, L.; Uhrich, K.E. (October 2000). "Synthesis and degradation characteristics of salicylic acid-derived poly(anhydride-esters)". Biomaterials. 21 (19): 1941–1946. doi:10.1016/S0142-9612(00)00073-9.
  3. ↑ Enkelmann, Volker; Wegner, Gerhard (1976-11-01). "Mechanism of interfacial polycondensation and the direct synthesis of stable polyamide membranes". Die Makromolekulare Chemie. 177 (11): 3177–3189. doi:10.1002/macp.1976.021771106. ISSN 0025-116X.
This article is issued from Wikipedia - version of the 9/19/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.